IMPORTANT ADVICE:
Before application please read SAFETY INSTRUCTIONS on the back side of the instruction leaflet carefully. Conduct an ALLERGY ALERT TEST. Apply the product directly after mixing.
1. PREPARATION
THIS COLORATION CONTAINS:
1a. Lightening cream tube
1b. Applicator bottle with developer lotion
1c. Blonde Booster
2. Post-color shampoo
3. Blue Mask
4. Pair of gloves
2. MIXING
Before starting the application, place a clothing protectionand a watch nearby so that you can monitor the processing time. SYOSS OLEO INTENSE PERMANENT OIL LIGHTENER is to be used on dry, not pre-washed hair.
Put on the clothing protection and the gloves supplied. Unscrew the cap of the Applicator Bottle. To open the sachet, cut it along the dotted line. Now empty the content of the Blonde-Booster(1c) into the Applicator Bottle (1b). Open the Lightening Cream Tube (1a). Squeeze the whole content of the tube into the Applicator Bottle. Screw the bottle as firmly as possible. Start mixing by rolling the bottle horizontally in your hands. Then shake vigorously vertically until all components are thoroughly mixed and have turned into a smooth cream. Screw off the applicator tip and proceed with the application immediately. To ensure an even consistency, discharge the tip volume before starting the application. Then apply the mixture directly from the Applicator Bottle on dry, not pre-washed hair. Start with the application immediately.
3. APPLICATION
(A) TOTAL APPLICATION
Apply the prepared lightening mixture directly from the Applicator Bottle onto dry, not pre-washed hair.
This application is recommended if:
- You are lightening your hair permanently for the first time, or
- After your previous lightening no regrowth can be seen.
Keep the clothes covering and the gloves on. Immediately apply the prepared lightening mixture strand after strand on the whole hair and ensure all hair is evenly covered. Leave the mixture in for 30–45 min.
(B) RE-GROWTH APPLICATION
Apply the prepared lightening mixture directly from the Applicator Bottle onto dry, not pre-washed hair.
Root Regrowth Application is necessary if:
- Your hair is already lightened permanently and
- A regrowth is visible.
Keep the clothes covering and the gloves on. For this, make a parting with the tip of the Applicator Bottle and apply the mixture along the parting on the roots (leave supplied gloves on). Repeat this procedure for the whole regrowth area. Ensure all regrowth is evenly covered. Leave the mixture on for 25–40 minutes until the whole regrowth shows nearly the same lightening result as the rest of the hair.
If necessary, dampen ends and spread mixture onto the rest of the hair to ensure even distribution and leave mixture for another 2–5 minutes.
4. PROCESSING TIME
The lightening effect depends on the length of the processing time and on how dark your natural hair color is. For an optimal lightening result the processing time should not be shortened.
To determine the correct processing time, please check it during application:
- Put on gloves again.
- After 25 minutes, wipe a single thin strand of hair clear in order to check the level of ightening achieved. To achieve a lighter result, apply the mixture from the surrounding hair onto the same strand and increase the processing time. Please note that the darker your natural hair color is, the more processing time is required to achieve a lighter result (but the processing time should not exceed 45 minutes).
4. RINSING & AFTER TREATMENT
PROFESSIONAL ROUTINE FOR EXTRA-CARE:
Before rinsing your hair, put on the gloves again.
At the end of the processing time, apply warm water to the hair and work into a lather. Then rinse out thoroughly until water runs clear.
Finally, SHAMPOO (2) your hair and rinse out thoroughly.
Put the gloves on (4).
Apply the specially developed SYOSS OLEO BLUE MASK (3) into your towel-dry hair and comb it to ensure an even application. Leave it for up to 3 minutes and then wash out. It will leave your hair smooth and with a nicely shiny cool blonde.